Start Training
Last updated
Last updated
Click Play on a track, then click ‘Start’ to start a ten-question training session.
FREQUIA has changed to Equalizer view.
The Bypass button lit up when you clicked Start and you are now listening to the Bypass signal (the signal without equalization). The current question number (1 - in the center of the interface) has an orange square around it.
Click the Question button. You are now listening to the equalized Question signal, which is the Bypass signal with equalization applied at a random* frequency. The type of equalization that has been added to the Question signal depends on the training setup.
FREQUIA defaults to the following training setup upon launch:
Filter Selection: Parametric Equalizer
Parameter Selection: Frequency only
Frequency Resolution: 2-Octave Bands (Easy)
Q/Slope Resolution: Low (Easy)
Training Mode: Matching
For each question in this ten-question training session, a Parametric Equalizer is applied to the Question signal (as per the default Filter Selection setting), at one of five frequencies (as per the default Frequency Resolution setting). Your task is to identify only the frequency of the applied filter (as per the Parameter Selection) by adjusting the Frequency control.
Click the Question button. You are now listening to the equalized Question signal, which is the Bypass signal with equalization applied at a random* frequency. The type of equalization that has been added to the Question signal depends on the training setup.
In the default Matching Mode, you must match the Response signal to the Question signal; you can switch between Bypass, Question, and Response signals as many times as needed.
Adjust the Frequency control so that the Response signal is identical to the Question signal, then click the Submit button.
If you were correct, the blue frequency response graph, the question number, and the value under the Frequency dial will all change to green.
If you were incorrect, the blue frequency response graph will change to red, and a second frequency response graph will appear in green to indicate the correct answer. The question number and the value under the Frequency dial will change to red.
Additionally, the correct frequency will be displayed in green at the top of the frequency response graph.
Click the Next button to start the next question. Repeat the process by clicking through the Bypass, Question, and Response signals, and adjusting the Frequency control so that the Response signal sounds identical to the Question signal, then check your answer by clicking the Submit button.
*As is switched off by default, the frequency is randomly selected.
Click for detailed information on how to modify training settings.
As the default Parameter Selection is Frequency only, you don’t have to identify the Gain or Q values in this training setup. You will note the Gain and Q controls are greyed out. During this training session, the Gain of the equalizer is fixed at +6 dB and the Q value is fixed at 0.8. These parameters can be if desired.
Click the Response button. You are now listening to the equalized Response signal, which is the Bypass signal with your equalization applied. Any adjustments you make to the Equalizer controls, in this case, Frequency, will be heard while monitoring the Response signal. You will also see the frequency response graph change when you modify the Frequency control (this graph can be ).
